Filament Settings by Brand: Nozzle, Bed and Drying

Filament settings table

Use the filters to narrow by brand, material or name. The table works without JavaScript; the filters only hide rows.

Check your nozzle temperature

What the columns mean

• Nozzle and bed are the ranges the maker recommends, in degrees Celsius. Some makers state them for a 0.4 mm nozzle and a particular speed, and Sunlu’s data sheets list a lower and a higher range by print speed, so the row shows the lowest and highest number in that speed table.
• Drying is the temperature and time the maker gives for drying a wet spool before printing. A blank time means the maker gives a temperature only. Use a dryer that can hold the temperature, and check the spool’s own heat limit; the drying chart compares dryers.
• Hardened nozzle and Enclosure show the maker’s wording only, such as “Required” or “Recommended”. “Not stated” means the pages we could read did not say, not that the answer is no. Carbon- and glass-fiber filaments wear a brass nozzle, so check the maker’s page before you print one.
• Source links to the maker’s product page and, where the maker links one, the technical data sheet (TDS). Under the link, a line says whether the values came from the data sheet or the page.
• Amazon links go to an Amazon search for that filament line, not to a verified listing, because one line is sold in many colors, sizes and packs.

Coverage

The first plan for this table named about 250 filaments. 234 rows are confirmed. The gap is mostly eSUN and Hatchbox, whose sites blocked automated requests, so none of their values were entered. Creality, Jayo and Kingroon publish settings too and may be added later.

How the rows were checked

1. Each row was read from the maker’s data sheet or product page and stored with its source address.
2. A second pass re-opened every source on November 8, 2026 and confirmed the nozzle range, the bed range and the drying values against the live page or PDF. A row that could not be confirmed was dropped.
3. Where a product page and a data sheet disagreed, the row shows the data sheet value when the data sheet belongs to that exact product, and a note explains the difference.
4. When a page printed a value that looked wrong, such as a bed range of 25–26 °C on one Overture page, the cell was left blank.

Related pages

• Filament finder picks a material for a job.
• Filament compatibility by printer model shows which printers take which materials.
• Settings cards give a short block of these numbers, with a credit link, for a model page description.